Quick App

Main functionality

1. On / Off, Auto Off. See picture 1.
2. Power metring. See picture 4.
3. Energy metring. See picture 4.
4. Auto mapping of MAC address to IP address.
6. Auto reconnecting by MAC Address if connection to WiFi Plug is lost.
7. Usin Websocket.

Main Change V 1.8

This Quick App uses Websocket and responds immediately to changes in on and off status of the physical wall plug as well as power metering. The power metering must change by more than 1.5% from the last measured value before it is registered in the power consumption chart. See picture 4. If there is a poor WiFi connection, this version will attempt to map the MAC Address to the IP Address and open the WebSocket 10 times before it aborts and sets the Quick App to offline status.

Quick App variables:

1. MacAddress. By default, this is set to Get. Do not change. It will get the Mac address automatically.
2. IpAddress. By default, this is set to Get this makes the Quic App search for new devices automatically. You can manually set this to the WiFi Plug IP address  for more info see: Heatit WiFi Plug V 1.3 . 

For more info see older versions:

1. Heatit WiFi Plug V 1.1 

2. Heatit WiFi Plug V 1.2 
3. Heatit WiFi Plug V 1.3 
4, Heatit WiFi Plug V 1.4 
5. Heatit WiFi Plug V 1.5
6. Heatit WiFi Plug V 1.6 Beta 
7. Heatit WiFi Plug V 1.7

Picture 1:

Picture 2: Auto Discovery. Quick App Variabel MacAddress and IpAddress set to "Get".  Searches for new devices connected to the wifi network automatically.

Picture 3: Auto Discovery found new WiFi Plug Device.

Picture 4. Energy consumption and power consumption